.. _qs-pci: PCIe ==== .. figure:: ../images/concept/qsx-pinout.png :width: 50% :figwidth: 50% :align: right :alt: The i.MX 8M Mini and i.MX 8M Plus have one PCIE interface. There is a pair of pins with the name of PCIE _CLK_P/N. These pins are bi-directional which can either be used to feed 100 MHz reference clock to the PHY from external clock source, or to output an internal generated 100 MHz reference clock to PCIE connector or PCIE device. Note that the internal clock exhibits larger jitter than that from PCIE clock generator. NXP recommends to use an appropriate external PCIe reference clock generator. The NXP EVK board design uses an IDT 9FGV0241device. However, NXP does not recommend one supplier over another, and does not suggest that this is the only clock generator supplier. The device used should support all the specs (jitter, accuracy, etc.) Route PCIe TX/RX and reference clock signal pairs with 85 Ω differential impedance. +---------+------------+-----------------------------------------+ | **Pin** | **Signal** | **Requirements** | +---------+------------+-----------------------------------------+ | 75A | PCIE_TXN_P | It is recommended to use a 0.1 μF | +---------+------------+ cap on both the PCIE_TXP and + | 76A | PCIE_TXN_M | PCIE_TXN outputs. | +---------+------------+-----------------------------------------+ | 100A | PCIE_RXN_P | PCIe specification compliance requires | +---------+------------+ AC coupling at each transmitter. + | 1A | PCIE_RXN_M | The receiver must be DC coupled. | +---------+------------+-----------------------------------------+ | 74 | PCIE_CLK_P | | +---------+------------+ + | 75 | PCIE_CLK_N | | +---------+------------+-----------------------------------------+ .. rubric:: PCIe Design Recommendations +-------------------------------------------------------+---------+---------+---------+ | **Parameter** | **MIN** | **TYP** | **MAX** | +-------------------------------------------------------+---------+---------+---------+ | Operating Speed | | | 4 GHz | +-------------------------------------------------------+---------+---------+---------+ | Signal Trace Length | | | 12 cm | +-------------------------------------------------------+---------+---------+---------+ | Differential Pair Skew | | | 1 ps | +-------------------------------------------------------+---------+---------+---------+ | Differential Trace Impedance | 73 Ω | 85 Ω | 97 Ω | +-------------------------------------------------------+---------+---------+---------+ | Single-ended Trace Impedance | 38 Ω | 45 Ω | 52 Ω | +-------------------------------------------------------+---------+---------+---------+ .. include:: index.rst