Debian Netinstaller on TX6

Use DEBIAN-NETINSTALLER for Mfgtools version 2018-08 or later to set up a TX6 module with the Debian Stretch netinstaller. This will enable you to install the entire Debian distribution on a TX6 module. The netinstaller assumes that the TX board has a connection to the Internet. After installation follow these steps as a guideline.

1. Select language and location

Be sure Ethernet is connected and the TX board has access to the Internet. After reboot follow the standard netinstaller questions:

../../_images/1-11.jpg
../../_images/1-21.jpg

2. Configure the network

../../_images/2-11.jpg
../../_images/2-21.jpg
../../_images/2-31.jpg

3. Choose a mirror and download installer components

../../_images/3-11.jpg
../../_images/3-21.jpg
../../_images/3-31.jpg
../../_images/3-41.jpg

4. Set up users and passwords

../../_images/4-11.jpg
../../_images/4-21.jpg
../../_images/4-31.jpg
../../_images/4-41.jpg
../../_images/4-51.jpg
../../_images/4-61.jpg

5. Ignore partitioning warnings

../../_images/5-11.jpg
../../_images/5-21.jpg

6. Partitioning

../../_images/6-11.jpg
../../_images/6-21.jpg
../../_images/6-31.jpg
../../_images/6-41.jpg
../../_images/6-51.jpg
../../_images/6-61.jpg

7. Popularity-contest

../../_images/7-11.jpg

8. Software selection

../../_images/8-11.jpg

9. Ignore Grub warning

../../_images/9-11.jpg
../../_images/9-21.jpg

10. Continue without bootloader

../../_images/10-11.jpg
../../_images/10-21.jpg